Logo 600 2XPT

$609.95

  • Model: PS1-2XPT-L600
  • Shipping Weight: 3.6lbs

Add to Cart:


CUSTOM ORDER - EXPECTED SHIPPING WITHIN 3-5 DAYS OF ORDERING.

The Logo 600 2XPT is a front mounted camera system for the Mikado Logo 600 RC Helicopter. It comes with a 2 axis camera gimbal for pan and tilt camera motion. The camera gimbal can accommodate cameras as large as some full frame DSLR's. (Similar in size to a Nikon D300 or Canon 5D). It can also accept smaller point and shoot type cameras or HD video cameras.




The Lower camera gimbal plate is multi-position adjustable in the vertical axis to allow the pivot point of the plate to line up with the camera center of gravity. The 2 axis gimbal and upper oil damper mounts can be adjusted fore & aft on the front mount tubes to allow for CG and leverage arm tuning depending on the mass of camera used.


The Logo 600 2XPT comes standard with two 2lb. Lord vibration isolators to help reduce helicopter vibrations from reaching the camera. For heavier cameras or more firm tuning, optional 4lb. (medium) or 8lb (hard) isolators can be purchased.


Even though the Logo600 2XPT has built in vibration isolation it is still VERY important that your helicopter be as vibration free as possible if you plan to use this system for video shooting. This can mean you may spend several hours fine tuning your helicopter. For still photo shooting this is much less critical.

Installation is very straight forward and takes about 5 minutes. You WILL need to install a taller landing gear for proper camera gimbal clearance.  We suggest our Extended Length Landing Gear Kit




Two 360 rotation servos are included for the the pan and tilt axis.  Because they are continuous rotation servos they do not respond like typical proportional servos.  Continuous rotation servos operate in "Rate Mode", meaning the rate at which the output wheel rotates is proportional to the amount of stick deflection on the transmitter.  If you move the stick all the way to one direction the servo will rotate continuously at maximum speed.  If you move the stick 50%, the servo will rotate at about half speed.   When you let the stick go the servo stops.  It DOES NOT return to any set position like a proportional servo.  This may take a bit of getting used to if you have not used continuous rotation servos but once you understand how they work it is rather easy to operate.

Also we'd like to mention that the 2XPT front mount systems are best operated by a second person and not the pilot.  Flying the helicopter is difficult enough let alone trying to operate a pan/tilt gimbal at the same time.  It is recommended that a separate camera operator man the controls of the camera gimbal.

SPECIFICATIONS:

Weight 1.5lb.
Cameras up to 3.0lb
5:1 gear ratio both axis
Continuous Rotation Robot Servos (80 oz./in. torque)


This product was added to our catalog on Tuesday 14 April, 2009.